A
-
Aerodynamic
Aerodynamic optimal design of wind turbine blades using genetic algorithm [Volume 2, Issue 2, 2014, Pages 185-193]
-
Aerodynamic performance
Aerodynamic design and economical evaluation of site specific horizontal axis wind turbine (HAWT) [Volume 2, Issue 1, 2014, Pages 43-56]
-
Aeroelasticity
A robust engineering approach for wind turbine blade profile aeroelastic computation [Volume 2, Issue 2, 2014, Pages 121-128]
-
Air
A numerical study on the effects of hydrogen addition levels, wall thermal conductivity and inlet velocity on methane/air pre-mixed flame in a micro reactor [Volume 2, Issue 2, 2014, Pages 103-119]
-
Airlift pump
Simulation of gas-liquid two phase flow in upriser pipe of gas-lift systems [Volume 2, Issue 1, 2014, Pages 25-42]
B
-
BEM & GA
Aerodynamic optimal design of wind turbine blades using genetic algorithm [Volume 2, Issue 2, 2014, Pages 185-193]
-
BEM theory
Aerodynamic design and economical evaluation of site specific horizontal axis wind turbine (HAWT) [Volume 2, Issue 1, 2014, Pages 43-56]
-
Biomass Gasification
Thermoeconomic comparison between the performance of small-scale internal combustion engines and gas turbines integrated with a biomass gasifier [Volume 2, Issue 1, 2014, Pages 57-82]
-
Boiler
Investigation of a single-reheat condensing steam power plant based on energy and exergy analysis [Volume 2, Issue 2, 2014, Pages 155-170]
-
Brayton cycle
Conceptual design of a super-critical CO2 brayton cycle based on stack waste heat recovery for shazand power plant in Iran [Volume 2, Issue 1, 2014, Pages 95-101]
C
-
Cement Industry
Energy auditing in cement industry: A case study [Volume 2, Issue 2, 2014, Pages 171-184]
-
CFD Simulation
Improvement of thermal performance of a solar chimney based on a passive solar heating system with phase-change materials [Volume 2, Issue 2, 2014, Pages 141-154]
D
-
Decision-Making Procedure
Energy auditing in cement industry: A case study [Volume 2, Issue 2, 2014, Pages 171-184]
-
Dew point
An analytic model of membrane humidifier for proton exchange membrane fuel cell [Volume 2, Issue 1, 2014, Pages 83-94]
-
Dimensional parameters
An analytic model of membrane humidifier for proton exchange membrane fuel cell [Volume 2, Issue 1, 2014, Pages 83-94]
-
Ductile cast iron
A review on fatigue design of heavy section EN-GJS-400-18-LT ductile iron wind turbine castings [Volume 2, Issue 1, 2014, Pages 5-24]
E
-
Economical evaluation
Aerodynamic design and economical evaluation of site specific horizontal axis wind turbine (HAWT) [Volume 2, Issue 1, 2014, Pages 43-56]
-
Electrical efficiency
Thermoeconomic comparison between the performance of small-scale internal combustion engines and gas turbines integrated with a biomass gasifier [Volume 2, Issue 1, 2014, Pages 57-82]
-
Energy Analysis
Investigation of a single-reheat condensing steam power plant based on energy and exergy analysis [Volume 2, Issue 2, 2014, Pages 155-170]
-
Energy Audit
Energy auditing in cement industry: A case study [Volume 2, Issue 2, 2014, Pages 171-184]
-
EN-GJS-400-18-LT
A review on fatigue design of heavy section EN-GJS-400-18-LT ductile iron wind turbine castings [Volume 2, Issue 1, 2014, Pages 5-24]
-
Eulerian model
Simulation of gas-liquid two phase flow in upriser pipe of gas-lift systems [Volume 2, Issue 1, 2014, Pages 25-42]
-
Exergy Analysis
Investigation of a single-reheat condensing steam power plant based on energy and exergy analysis [Volume 2, Issue 2, 2014, Pages 155-170]
F
-
Fatigue design
A review on fatigue design of heavy section EN-GJS-400-18-LT ductile iron wind turbine castings [Volume 2, Issue 1, 2014, Pages 5-24]
-
Fluid Structure Interaction
A robust engineering approach for wind turbine blade profile aeroelastic computation [Volume 2, Issue 2, 2014, Pages 121-128]
G
-
Gas Turbine
Thermoeconomic comparison between the performance of small-scale internal combustion engines and gas turbines integrated with a biomass gasifier [Volume 2, Issue 1, 2014, Pages 57-82]
H
-
Heat and Electricity Balance
Energy auditing in cement industry: A case study [Volume 2, Issue 2, 2014, Pages 171-184]
-
Horizontal axis wind turbine (HAWT)
Aerodynamic design and economical evaluation of site specific horizontal axis wind turbine (HAWT) [Volume 2, Issue 1, 2014, Pages 43-56]
-
HRSG
Multi-objective optimization of heat recovery steam generators [Volume 2, Issue 2, 2014, Pages 129-140]
-
Hydrogen
A numerical study on the effects of hydrogen addition levels, wall thermal conductivity and inlet velocity on methane/air pre-mixed flame in a micro reactor [Volume 2, Issue 2, 2014, Pages 103-119]
I
-
Internal combustion engine
Thermoeconomic comparison between the performance of small-scale internal combustion engines and gas turbines integrated with a biomass gasifier [Volume 2, Issue 1, 2014, Pages 57-82]
M
-
Methane
A numerical study on the effects of hydrogen addition levels, wall thermal conductivity and inlet velocity on methane/air pre-mixed flame in a micro reactor [Volume 2, Issue 2, 2014, Pages 103-119]
-
Micro tube
A numerical study on the effects of hydrogen addition levels, wall thermal conductivity and inlet velocity on methane/air pre-mixed flame in a micro reactor [Volume 2, Issue 2, 2014, Pages 103-119]
-
Multi-objective optimization
Multi-objective optimization of heat recovery steam generators [Volume 2, Issue 2, 2014, Pages 129-140]
N
-
Numerical modelling
Simulation of gas-liquid two phase flow in upriser pipe of gas-lift systems [Volume 2, Issue 1, 2014, Pages 25-42]
O
-
Optimization
Aerodynamic optimal design of wind turbine blades using genetic algorithm [Volume 2, Issue 2, 2014, Pages 185-193]
-
Output power
Aerodynamic optimal design of wind turbine blades using genetic algorithm [Volume 2, Issue 2, 2014, Pages 185-193]
P
-
Parallel Computing
Improvement of thermal performance of a solar chimney based on a passive solar heating system with phase-change materials [Volume 2, Issue 2, 2014, Pages 141-154]
-
Passive Heating
Improvement of thermal performance of a solar chimney based on a passive solar heating system with phase-change materials [Volume 2, Issue 2, 2014, Pages 141-154]
-
PEM fuel cell
An analytic model of membrane humidifier for proton exchange membrane fuel cell [Volume 2, Issue 1, 2014, Pages 83-94]
-
Phase Change Materials (PCM)
Improvement of thermal performance of a solar chimney based on a passive solar heating system with phase-change materials [Volume 2, Issue 2, 2014, Pages 141-154]
-
Planar membrane humidifier
An analytic model of membrane humidifier for proton exchange membrane fuel cell [Volume 2, Issue 1, 2014, Pages 83-94]
R
-
Reduced chemistry
A numerical study on the effects of hydrogen addition levels, wall thermal conductivity and inlet velocity on methane/air pre-mixed flame in a micro reactor [Volume 2, Issue 2, 2014, Pages 103-119]
S
-
Site specific
Aerodynamic design and economical evaluation of site specific horizontal axis wind turbine (HAWT) [Volume 2, Issue 1, 2014, Pages 43-56]
-
Solar chimney
Improvement of thermal performance of a solar chimney based on a passive solar heating system with phase-change materials [Volume 2, Issue 2, 2014, Pages 141-154]
-
Steam Power Plant
Investigation of a single-reheat condensing steam power plant based on energy and exergy analysis [Volume 2, Issue 2, 2014, Pages 155-170]
-
Step
A numerical study on the effects of hydrogen addition levels, wall thermal conductivity and inlet velocity on methane/air pre-mixed flame in a micro reactor [Volume 2, Issue 2, 2014, Pages 103-119]
-
Super-critical CO2
Conceptual design of a super-critical CO2 brayton cycle based on stack waste heat recovery for shazand power plant in Iran [Volume 2, Issue 1, 2014, Pages 95-101]
T
-
Thermoeconomic
Multi-objective optimization of heat recovery steam generators [Volume 2, Issue 2, 2014, Pages 129-140]
-
Thermoeconomic analysis
Thermoeconomic comparison between the performance of small-scale internal combustion engines and gas turbines integrated with a biomass gasifier [Volume 2, Issue 1, 2014, Pages 57-82]
-
Two phase flow
Simulation of gas-liquid two phase flow in upriser pipe of gas-lift systems [Volume 2, Issue 1, 2014, Pages 25-42]
V
-
Volume of fluid
Simulation of gas-liquid two phase flow in upriser pipe of gas-lift systems [Volume 2, Issue 1, 2014, Pages 25-42]
W
-
Waste heat recovery
Conceptual design of a super-critical CO2 brayton cycle based on stack waste heat recovery for shazand power plant in Iran [Volume 2, Issue 1, 2014, Pages 95-101]
-
Wind Turbine
A review on fatigue design of heavy section EN-GJS-400-18-LT ductile iron wind turbine castings [Volume 2, Issue 1, 2014, Pages 5-24]
-
Wind Turbine
A robust engineering approach for wind turbine blade profile aeroelastic computation [Volume 2, Issue 2, 2014, Pages 121-128]
-
Wind turbine blade
Aerodynamic optimal design of wind turbine blades using genetic algorithm [Volume 2, Issue 2, 2014, Pages 185-193]
Your query does not match with any item